Pointing from Cape Town i
FIXEDQO-100 is geostationary: it never moves relative to the ground, so once your dish is aimed it stays aimed. These figures never change.
Solar outage i
Twice a year the Sun lines up behind the satellite from your position. The Sun is a very strong radio source, so the downlink can be washed out for a few minutes a day over several days.
Live activity
EXTERNALThere is no public API that reports the transponder's status or how busy it is. These monitors show the real, live picture — including actual traffic.
About QO-100
QO-100 (also called Es'hail-2) is the first amateur radio satellite in geostationary orbit. It was launched in November 2018 and is operated commercially by Es'hailSat of Qatar, with the amateur payload provided by AMSAT-DL and Es'hailSat.
Because it is geostationary it hangs over one point on the equator, at approximately 25.9° east, and covers roughly one third of the Earth: Europe, Africa, the Middle East, and parts of Asia and South America. South Africa is comfortably inside the footprint.
It is not an HF satellite
QO-100 sits about 35,800 km above the equator — well above the ionosphere. HF works by the ionosphere bending signals back to Earth, so none of the HF effects shown elsewhere on this site apply here: there is no MUF, no D-layer absorption, no grey line and no geomagnetic depression. Its uplink and downlink are effectively line-of-sight microwave links. That is why this page shows pointing and solar-outage information rather than band conditions.
Transponders
QO-100 carries two amateur transponders. Exact edges change occasionally, so always check the official band plans linked below before transmitting.
| Transponder | Uplink | Downlink | Typical use |
|---|---|---|---|
| Narrowband (NB) | around 2400 MHz (2.4 GHz) | around 10489.5 MHz (10.49 GHz) | SSB, CW and the narrow digital modes. The downlink is inverted relative to the uplink. |
| Wideband (WB) | around 2401.5 MHz | around 10491 MHz | Digital amateur television (DATV), about 8 MHz wide. |
| NB beacon | — | around 10489.550 MHz | A continuous beacon. Hearing it confirms your downlink is working. |
Practical notes for South African operators
- From Cape Town the satellite is high in the northern sky — a clear view to the north is what matters, not a low horizon.
- You need a 2.4 GHz uplink and a 10 GHz downlink. A common approach is a small dish with a dual-band feed, or separate antennas.
- Because the satellite is fixed, a fixed, accurately aimed dish works well — no rotator is needed.
- The 10 GHz downlink is affected by heavy rain along your path to the satellite (rain fade). This is weather, not propagation.
- Output power on the uplink should be kept to the minimum needed. The transponder is shared and easily over-driven.
- Operating via satellite counts under your amateur licence conditions — check your own licence and the band plan.
Where to go next
- AMSAT-DL — Es'hail-2 / QO-100 (official payload operator)
- BATC wiki — Es'hail-2 ground station guide
- BATC dish pointing calculator and coverage map
- QO-100 DX Club
- Es'hailSat
Pointing figures are calculated for the Cape Town reference location. If you are elsewhere in South Africa, your azimuth and elevation will differ — use the BATC pointing calculator for your own grid square.